Mazda recalls CX-50 over fasteners that may not be tightened properly and could come loose
On certain vehicles, some nuts and bolts at the front may not have been tightened properly, so they could loosen and detach, causing a loss of power to the wheels, a loss of control or parts separating, which could raise the risk of a crash.
What to do
Visually inspect the alignment of the front wheels before driving until the recall repairs have been completed. Mazda will notify owners by mail. Take your vehicle to a dealership to inspect and tighten or replace the fasteners, as necessary.
Recall details
- Product
- Car: MAZDA CX-50
- Company
- Mazda
- Hazard
- On certain vehicles, the wheel hub nuts, outer tie rod nuts, front lower ball joint nuts, upper control link nuts and/or axle bracket bolts may not have been tightened properly. As a result, the fasteners could loosen and detach. If this happens, there could be a loss of power to the wheels, a loss of control and/or parts could separate from the vehicle. Note: This problem could cause unusual noises from the front of the vehicle when steering and/or driving over bumps.
- Vehicles
MAZDA CX-50
- Identifiers
- Transport Canada recall number: 2025592
- Recall date (Transport Canada)
- October 29, 2025
- Notice last updated
- November 5, 2025
- Listed on Recalled Today
- November 5, 2025
Recalled Today dates each recall from the day it first appeared in the official data.
The headline, summary and steps above are written in plain English from the official notice below. Identifiers are copied exactly as the agency published them. Always check the official notice before you act.
Official notice
The notice's own wording from Transport Canada.
Mazda issued a recall on the CX-50 model
- Issue
- On certain vehicles, the wheel hub nuts, outer tie rod nuts, front lower ball joint nuts, upper control link nuts and/or axle bracket bolts may not have been tightened properly. As a result, the fasteners could loosen and detach. If this happens, there could be a loss of power to the wheels, a loss of control and/or parts could separate from the vehicle. Note: This problem could cause unusual noises from the front of the vehicle when steering and/or driving over bumps.
- Safety risk
- A loss of power to the wheels and/or a loss of control could increase the risk of a crash. Additionally, parts that separate from the vehicle could create a road hazard for others and increase the risk of a crash.
- Corrective actions
- To reduce the safety risk, Mazda advises you to visually inspect the alignment of the front wheels before driving until the recall repairs have been completed. Mazda will notify owners by mail and advise you to take your vehicle to a dealership to inspect and tighten or replace the fasteners, as necessary.
- Vehicles
- MAZDA CX-50
- Units affected
- 98
- System
- Steering
- Category
- Car
- Notification type
- Safety Mfr
- Recall date (Transport Canada)
- 2025-10-29
- Recall number
- 2025592
- Organization
- Transport Canada
Contains information licensed under the Open Government Licence – Canada. Open Government Licence
Recalled Today is independent and is not an official government page.
Related recalls
Lucid recalls Air Pure rear-wheel drive cars over axle bolts that may not be tight enough
On certain vehicles the bolts holding the axle shafts to the drive unit may not have been tightened properly, so an axle shaft could come loose and cause a sudden loss of power to the wheels, which could raise the risk of a crash.
Volkswagen recalls Atlas Cross Sport over wrong wheel bolts that can let wheels come off
On a small number of vehicles the wrong wheel bolts may have been installed, which can loosen and let a wheel detach, possibly causing a loss of control, a crash or a road hazard for others.